Filter
Top Products
Management
Page 4-6
Configuring Out-of-Band Information
You can configure an IntraStack’s out-of-band parameters (i.e., the dial-
string and baud rate) via the Agent menu.
To configure an IntraStack’s out-of-band information:
1 Do not select any item on the Device Page’s front-panel
image. (This selects the entire device.)
2 Click Agent.
The Agent Information table appears, similar to Figure 4-5.
Figure 4-5 Agent Information table
∆ Note: For a description of each field, see “Agent”
on page 5-5.
3 To change the IntraStack’s out-of-band dial string,
click once in the Dial String field and type the dial
string.
4 To change the IntraStack’s out-of-band baud rate,
open the Baud Rate drop-down menu and select a
new baud rate.
5 Click Apply.
The IntraStack 6014DSB’s out-of-band information is config-
ured.
Click Refresh to view updated information.
Book Page 6 Thursday, September 18, 1997 4:28 PM