Filter
Top Products
Configuring Telnet Idle Time-Out
Page 4-25
Configuring Telnet Idle Time-Out
You can configure the amount of time an idle Telnet connection to the
IntraStack remains active via the swAgentSW menu.
If a Telnet connection to the IntraStack remains idle for the number of
specified time-out minutes, the remote Telnet connection to the IntraSt-
ack is automatically disabled.
To configure the IntraStack’s Telnet idle time-out:
1 Do not select anything on the front-panel image. (This
selects the entire device).
2 Click swAgentSW.
The Switch Agent Software Group table appears, similar to
Figure 4-15.
Figure 4-15 Switch Agent Software Group table
∆ Note: For a description of each field, see
“swAgentSW” on page 5-9.
3 Type the number of minutes for the time-out period
in the Telnet TimeOut field.
4 Click Apply.
The Telnet idle time-out period is configured.
Book Page 25 Thursday, September 18, 1997 4:28 PM