Filter
Top Products
Configuring Bootstrap Parameters
Page 4-7
Configuring Bootstrap Parameters
You can determine the method (local or remote) that the IntraStack uses
to load its software at startup or during a reset via the Agent menu.
To configure the IntraStack’s bootstrap parameters:
1 Do not select any item on the Device Page’s front-panel
image. (This selects the entire device.)
2 Click Agent.
The Agent Information table appears, similar to Figure 4-5
on page 4-6.
∆ Note: For a description of each field, see “Agent”
on page 5-5.
3 Open the Image Load Mode field and select one of
the following options:
❏ localBoot — sets the IntraStack 6014DSB to
execute its software image file from its internal
flash memory.
❏ netBoot — sets the IntraStack 6014DSB to load
its software image file from a server on the net-
work.
4 Click Apply.
The IntraStack 6014DSB’s bootstrap parameters are config-
ured.
Book Page 7 Thursday, September 18, 1997 4:28 PM