Asus GigaX Network Card User Manual


 
60
4.7.3 Trap Setting
By setting trap destination IP addresses and community names, you can
enable SNMP trap function to send trap packets in different versions (v1 or
v2c). Click
to save the configuration permanently or
to refresh the page.
Figure 34. Trap Setting
4.7.4 VACM Group
VACM (View-based Access Control Model) Group is used to configure the
information of SNMPV3 VACM Group.
Group Name: enter the security group name.
Read View Name: enter the Read View Name that the Group belongs.
The related SNMP messages are Get, GetNext, GetBulk.
Write View Name: enter the Write View Name that the Group belongs.
The related SNMP message is Set.
Notify View Name: enter the Notify View Name that the Group belongs.
The related SNMP messages are Trap, Report.
Security Model: enter the Security Model Name that the Group
belongs. Any is suitable for v1, v2, v3. USM is SNMPv3 related.