Filter
Top Products
86
CLI command : sys l2 port retrieve
5.3.3 Route Commands
[Show L3 Interfaces]
Displays all L3 interfaces settings.
CLI command : l3 interface show <trunk id>
[Create L3 Interfaces]
User can create a new L3 interface by specify an unique interface name, the
interface type (VLAN, virtual interface or Port, routed port), and its type
member (VLAN ID or port ID).
CLI command : l3 interface create <interface name> [vlan <vlan id> / port
<port id>]
[Set/Display L3 Interfaces IP address/netmask]
Displays the static IP address and subnet mask for an L3 interface. This IP
address is used for IP routing as well as switch management.
CLI command : l3 interface ip <interface name> <ip> <mask>
[Start L3 Interfaces]
Bring up or activate an L3 interface.
CLI command : l3 interface start <interface name>
[Stop L3 Interfaces]
Shutdown or deactivate an L3 interface.
CLI command : l3 interface stop <interface name>
[Display Routes]
Display routing entries in the routing table.
CLI command : l3 route show