Filter
Top Products
ASUS NCCH-DRASUS NCCH-DR
ASUS NCCH-DRASUS NCCH-DR
ASUS NCCH-DR
2-32-3
2-32-3
2-3
2.2.32.2.3
2.2.32.2.3
2.2.3
CPU heatsink weight supportCPU heatsink weight support
CPU heatsink weight supportCPU heatsink weight support
CPU heatsink weight support
For additional protection from motherboard breakage due to the weight of
the CPU heatsinks, your motherboard package comes with two solution kits.
• X-PAD accessory kit containing:
– 2 x metal support plates
– 1 x contour sheet
– 3 different sets of metal nuts and rubber pads for varied chassis
standoffs (each set contains 8 metal nuts and 2 rubber pads)
• 2 x CEK spring
You can use any of the two solutions to protect the motherboard.
2. Align the holes of the contour
sheet with the standoffs on the
base of the chassis. Press the
sheet flat making sure that it is
completely pressed against to
the chassis.
The contour sheet fits in only
one orientation. Make sure
that the hole located about
1 cm from the corner
matches the standoff beside
the power supply.
Using the X-PAD accessory kitUsing the X-PAD accessory kit
Using the X-PAD accessory kitUsing the X-PAD accessory kit
Using the X-PAD accessory kit
To install the support plates:
1. Open and lay your system
chassis on a stable surface, then
locate the motherboard
standoffs.
StandoffStandoff
StandoffStandoff
Standoff
3. Determine the height of the standoffs on your chassis, and select the
appropriate set of metal nuts and rubber pads from your package.
Use a nut size that is slightly lower than the standoffs on your chassis.
Standoff besideStandoff beside
Standoff besideStandoff beside
Standoff beside
power supplypower supply
power supplypower supply
power supply