Filter
Top Products
ASUS PU-DLS/PU-DL motherboard user guide
5-13
B. Installing Windows 2000 with an Ultra320 SCSI
Controller
Follow these steps to install Windows 2000 for the first time with an
Ultra320 SCSI controller.
1. Start your system with the Windows 2000 Boot CD-ROM in the
CD-ROM drive. Note: When using a CD-ROM drive to install
Windows 2000 from the bootable CD-ROM, make sure Bootable
CD-ROM support is enabled. This is done through the System BIOS
Setup Utility.
2. Press F6 when this message appears:
“Press F6 if you need to install third-party SCSI drivers”
3. When prompted, press "S" to supply the new driver.
4. Insert the Adaptec Ultra320 FMS driver disk when the setup prompts
you to insert the manufacturer supplied disk into drive A, and press
Enter.
5. The screen displays the adapter drivers supported on the disk.
Select “Adaptec Ultra320 SCSI Cards (Win2000)” and continue with
the rest of the Windows 2000 installation.
6. Your system will reboot once more to finish setting up Windows 2000.
C. Installing the Adaptec Ultra320 driver with existing
Windows 2000
1. Start Windows 2000. Windows 2000 will automatically discover the
new hardware and start the Found New Hardware Wizard to guide
you through the device driver installation.
2. At the Welcome to the Found New Hardware Wizard window, select
Next.
3. On the Install Hardware Device Drivers screen, select Display a list of
the known drivers for this device, and click Next.
4. Select the Have Disk button. You will be prompted to insert the
manufacturer supplied disk. Insert the Adaptec Ultra320 FMS driver
disk in your disk drive and enter the following path, then click OK.
\win2000
5. Select the Adaptec Ultra320 driver from the list, then click the Next
button.