Filter
Top Products
5-34
Chapter 5: Driver installation
15. Write down the HIN value displayed on the screen and select 0 to
continue. Ignore the message regarding the ADPU320.HAM not
being loaded.
16. At the prompt, press Alt-Esc to return to the nwconfig screen.
17. Enter the HIN value in Slot Number and press ENTER.
18. Select "Save parameters and load driver" and press
ENTER.
19. Click No at the prompt "Do you want to select an additional Disk
driver?"
20. Press Esc until return to the Configuration Options screen.
E. Installing the Adaptec driver with existing
NetWare 4.2
1. At the NetWare console prompt type:
LOAD INSTALL
2. Select "Driver Options (load/unload disk and network drivers)" and
press ENTER.
3. In the Driver Options menu select "Configure disk and storage device
drivers" and press ENTER.
4. Select "Select an additional driver" and press ENTER.
5. Press Insert to add an unlisted driver.
6. Insert the Adaptec Ultra320 FMS Driver disk for NetWare into the
floppy drive.
7. Press F3 and specify the path to the ADPU320.HAM driver:
A:\NETWARE\V42_V50\
8. Select ADPU320.HAM and press ENTER.
9. When prompted, click 'Yes' to copy the driver.
10. Specify the path where the driver ADPU320.HAM should be installed,
or press ENTER to accept the default.
11. When prompted, click 'Yes' to save the existing driver and its
information file.
12. When prompted to enter the Slot Number, press ENTER to select
"Save parameters and load driver".
Novell
®
Netware
®
Server (continued)