Filter
Top Products
5-4
Chapter 5: Driver installation
Microsoft
®
Windows
®
NT Server 4.0 (continued)
4. Copy the entire winnt40 folder and the txtsetup.oem file from the
support CD into the root directory of the floppy disk. These items are
in the following folder path:
\drivers\adaptec\7902\
B. Installing Windows NT 4.0 with an Ultra320 SCSI
Controller
Follow these steps to install Windows NT 4.0 for the first time with an
Ultra320 SCSI controller.
1. Start your system with the Windows NT 4.0 Boot disk in the floppy
disk drive or the Windows NT 4.0 Boot CD-ROM in the CD-ROM
drive. NOTE: If there is DOS installed and you are trying to install
Windows NT 4.0, then it may also be necessary to edit the config.sys
file to include command lines for your CD-ROM drive. See the system
documentation for more information.
2. When the following message appears onscreen, press the F6 key.
“Setup is inspecting your computer system’s hardware.”
If you are installing from CD-ROM, skip to Step 4.
If you are installing from floppy disk, continue to Step 3.
3. For Windows NT 4.0 Boot disk installation only: When prompted,
insert disk #2 in your floppy disk drive. After a few moments you will
see a blue screen.
4. Press S to specify an additional device.
5. Press Enter to select Other; insert the Adaptec Ultra320 FMS driver
disk in your floppy disk drive and press Enter.
6. The screen displays the adapter drivers supported on the disk. Select
Adaptec Ultra320 SCSI Cards (WinNT 4.0) and press Enter.
7. If you want to add other drivers, press S and repeat Step 5 for each
additional adapter and insert the appropriate disk provided by the
hardware manufacturer.
8. Press Enter to continue with the Windows NT 4.0 operating system
setup.
9. Follow the instructions onscreen and in the Windows NT 4.0
documentation to complete the installation.