Filter
Top Products
22
ASUS TR-DLS User’s Manual
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
4. Clear RTC RAM (CLRCMOS)
These two solder points allow you to clear the RTC RAM in CMOS. You can
clear the CMOS memory of date, time, and system setup parameters by erasing
the CMOS Real Time Clock (RTC) RAM. The RAM data that include system
setup information, such as system passwords, is powered by the onboard button
cell battery.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Remove the battery.
3. Short the solder points for a few seconds.
4. Re-install the battery.
5. Plug the power cord and turn ON the computer.
6. Hold down the <Del> key during the boot process and enter BIOS setup to
re-enter CMOS data.
TR-DLS
TR-DLS Clear RTC RAM
CLRCMOS
Short solder points
to Clear CMOS
PCI4 (32-bit, 33MHz 5V)
PCI3 (32-bit, 33MHz 5V)
TR-DLS
TR-DLS Keyboard Power Setting
KBPWR
(Default)
1
2
5V
5VSB
2
3
3. Keyboard Power Settings (3-pin KBPWR)
This jumper allows you to enable or disable the keyboard wake-up feature. Set
this jumper to pins 2-3 (5VSB) if you wish to wake up the computer when you
press a key on the keyboard. This feature requires an ATX power supply that can
supply at least 1A on the +5VSB lead, and a corresponding setting in the BIOS
(see section 4.5.1 Power Up Control).