Asus TR-DLS Computer Hardware User Manual


 
76
ASUS TR-DLS Users Manual
5. OS Driver Installation
5. Driver Installation
NOTE: If F6 is not pressed, the user is still given the opportunity to
load additional drivers later in the installation process. However, any
drivers loaded during Windows NT Setup are not immediately
recognized and no devices controlled by that driver are available during
Windows NT Setup.
3. When prompted for the manufacturer-supplied hardware support disk, insert
the appropriate LSI driver diskette containing the Windows NT driver
required to support your LSI adapter(s) and press Enter. The driver files are
distributed with ASUS Driver Support CD and are created from above
“Preparing a LSI Driver Diskette” Section.
4. Depending on the driver being installed, “Symbios Ultra3 PCI SCSI
Driver” is shown highlighted. Press Enter to proceed.
5. Windows NT should now recognize the miniport driver(s) and the SCSI
hardware. Press Enter to continue. As for the on-board LAN and VGA,
please refer to the later sections for network and graphics driver installation.
B2. Boot Floppy Disk Installation
1. Start the Windows NT installation by booting from the Microsoft Setup
floppy diskette.
2. Press Enter when the Welcome to Setup screen appears. The Windows NT
Workstation Setup window appears next.
3. Press S to skip automatic detection and perform a manual selection. A screen
displays the message “Setup has recognized the following mass storage
devices in your computer...”.
4. With floppy disk 2, there is an initial setup screen that prompts you to
continue by pressing Enter.
5. Press S to skip mass storage device detection. (If Enter is pressed, the
installation program scans for SCSI adapters and finds the LSI PCI
(53C810) driver which is an older version of the SYMC8XX.SYS driver.
Let installation continue and change the drive when the installation
completed.) To change the driver, see Existing System Installation.
6. When a screen displays the SCSI adapters found, choose S to configure
additional SCSI adapters.
7. Move the highlight bar to Other and press Enter.
WinNT4.0 Server