Filter
Top Products
34
3. HARDWARE SETUP
ASUS TR-DLS User’s Manual
3. H/W SETUP
Connectors
6) Two 68-pin Ultra160/320 SCSI Connectors (SCSI-A, SCSI-B)
This motherboard has two 68-Pin Ultra160/320 SCSI connectors; one for each
of the two channels. Each channel can support a maximum of 15 devices as
specified by Ultra160 standards.
SCSI Connection Notes
This motherboard has two 68-Pin Ultra160 SCSI connectors; one for each of the
two channels.
The onboard SCSI chipset incorporates an advanced multimode I/O cell that supports
both single-ended (SE), Ultra2, and Ultra160/320 devices. With Ultra160/320 devices,
the SCSI bus platform performs at full Ultra160/320 speeds (up to 160MB/sec or
320MB/s) and extended cabling 12m (or 25m in a point-to-point configuration).
When an SE device is attached, the bus defaults to an SE speed and 1.5m cable
length.
NOTE: Ultra160/320 SCSI devices do not have termination jumpers and
must use a separate terminator on the last connector (internal) or device
(external).
TR-DLS
TR-DLS Onboard SCSI Connectors
3568
34 1
35
6834
1
SCSI-A
68-Pin Ultra160/
Ultra2-Wide SCSI Connector
SCSI-B
68-Pin Ultra160/
Ultra2-Wide SCSI Connector
TR-DLS
TR-DLS SCSI Connection Example
68-pin Internal SCSI Cable (Twisted-Pair Ribbon)
68-pin Female
Terminator
Internal SCSI Devices (up to 15 devices)
Channel A
68-pin Internal SCSI Cable (Twisted-Pair Ribbon)
68-pin Female
Terminator
Internal SCSI Devices (up to 15 devices)
Channel B
IMPORTANT: Connect SCSI devices as shown. Each channel should have
only one type of SCSI standard (e.g. Ultra160/320, Ultra2, Ultra-Wide). Mixing
SCSI devices on the same channel decreases performance of the slower device.