Filter
Top Products
Note: 1. The Port number that corresponds to a unit’s IP address is set by
the Administrator on the Network configuration page (see p. 55
for details).
2. Clicking the Refresh button causes the utility to rescan the local
LAN segment for CN-5000 devices.
3. If the utility fails to connect to a unit that you specified, it assigns
another free IP address (if one exists), to that device and attempts
to connect again.
4. When the Administrator Utility searches for CN-5000 devices, if
it finds a unit that was originally on a different network segment
that still has a fixed IP address from its previous location, it will
list the unit (showing the IP address), but you cannot connect to it.
You should change the unit’s IP address to match its current
network segment (see IP Address Determination, p. 88, for
details).
2005-09-13
8. AP Operation
49