Filter
Top Products
AUDIX Voice Power Initial Implementation
Switch Interface Administration Parameters
Some specific parameters are necessary to tell AUDIX Voice Power how to
communicate with the telephone switch. For convenience, these parameters are
collected on FORM B in the Planning Guide. A sample is explained below.
FORM B
Switch Interface Administration
Switchhook Flash Duration
I
Wink Disconnect Interval
I
Signaling Type
I
The contents of each field should be:
■
Switchhook Flash Duration
specifies the on-hook duration in
milliseconds that the switch recognizes as a transfer request. The
range is 300 to 1550 milliseconds. The default is
600
milliseconds,
.
■
Wink Disconnect Interval
specifies the on-hook duration in milliseconds
that the switch recognizes as a disconnect request. The range is 300 to
800 milliseconds. The default is
300
milliseconds.
■
Signaling Type
specifies whether Touch-Tone (TT) or dial-pulse (DP)
signaling is used. The default is
TT.
Changing Switch Interface Parameters
The switch interface parameters should not be changed from the values specified
above. If for some reason they must be changed, enter the default values shown
above. The new values will replace the old values,
2-7