Filter
Top Products
AUDIX Voice Power Initial Implementation
Verifying System Parameters
After the first two groups of system parameters (Voice Mail and Automated
Attendant parameters) have been determined and entered on FORM C, review
them. Then add the Message Waiting Lamp parameters to the third section of
FORM C in the Planning Guide and enter the parameters into the AUDIX Voice
Power system.
You will need two pieces of information:
■
whether or not the message waiting lamps are to be used
■
the System 75 or DEFINITY G1 message waiting lamp codes if they have
been changed from the default
Verifying Message Waiting Lamp Parameters
Message Waiting Lamp parameters affect only the operation of message waiting
lamps. The following parameters are available:
■
Code to Light
specifies the internal code that AUDIX Voice Power sends
to the switch to light the message waiting lamp. Enter the value found on
the Feature Access Code form or leave the field blank if message waiting
lamps will not be used.
■
Code to Extinguish
specifies the internal code that AUDIX Voice Power
sends to the switch to extinguish the message waiting lamp. Enter the
value found on the Feature Access Code form or leave the field blank if
message waiting lamps will not be used.
■
Refresh
indicates whether you wish to have message waiting lamps
refreshed at predetermined intervals. Enter
y
if message waiting lamps
are used, or
n
if message waiting lamps will not be used.