Filter
Top Products
System 75 and DEFINITY G1 Initial Implementation
6.
Enter LWC
Reception:
according to the following table:
7.
Release Setting
R1V1
y
R1V2 yes
R1V3
ap-spe
G1
msa-spe
Enter Call Waiting
Indication? as n.
8.
Enter Att.
Call Waiting Indication? as n.
Leave the remaining fields at default values. Repeat this procedure for each
extension assigned to an AUDIX Voice Power analog channel.
Configuring
DCP
Extensions
(Integrated Only)
To integrate the switch to AUDIX Voice Power, a digital station must be
configured. See Figure 3-5.
Use the following procedure
(add station
or
change
and the appropriate station command
station)
to configure the
DCP
extension:
1.
2.
3.
4.
5.
6.
7.
Enter
Type:
as
PC.
NOTE:
If your switch is a R1V1 software vintage, the station type should be
assigned as a 7405D set.
Enter
Set:
as
7404D.
Enter COR as 16 or whatever COR was assigned to the DCP connection
extension. (See Figure 3-3.)
Set
Restrict Last Appearance? to y.
Set all ten button assignments to call-appr.
Enter normal for Button 1 under DISPLAY BUTTON ASSIGNMENTS
(Page 3) or
FEATURE BUTTON ASSIGNMENTS
(Page 2).
Set
Data Module?
to
y.
This data module is actually a dummy extension that will not be used for
AUDIX Voice Power. When assigning this extension, it is recommended
that you select an obscure extension that will not be needed in the future,
but which is a valid number in the dial plan.
3-10