Filter
Top Products
21
ATTO Technology Inc. iPBridge Installation and Operation Manual
3.1 AT TO Ex pr es sN AV pag es
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topic. Each page can be reached through the menu at the side of each page An image
on each page’s header shows each port in the product faceplate. Each port is clickable and will also take
you to the appropriate page.
Status
Displays iPBridge information
• Bridge name
• Vendor ID
• Product ID
• Firmware revision number
• Serial number
• Valid temperature range
• Current temperature
• Current voltage
• Ethernet port IP addresses
• Ethernet port status
• Fibre Channel port status
• World Wide Name identifiers for Fibre Channel
ports and iSCSI nodes
Serial Port Configuration
Configure the baud rate and echo parameters.
Refer to
Serial port configuration commands
on
page 47 for details on each option.
Time & Date Configuration
Configures the real-time clock or accesses a
remote time server. Configurable options are
• Enable/disable Simple Network Time Protocol
• Time Server
• Time Zone
• manually set time
• manually set date
Refer to
Maintenance commands
on page 41 for
details each parameter.
Ethernet (Network) Port Configuration
Displays available ports and configures each port
independently for the following parameters
• Enable/disable DHCP
• IP address
• IP gateway
• IP subnet mask
• Ethernet speed
• MTU
Refer to
Ethernet commands
on page 49 for
details on each parameter.
SNMP
Configures Simple Network Management
Protocol parameters and Trap recipient IP address
for each Ethernet port. Refer to
Ethernet
commands
on page 49 for details.
Fibre Channel Configuration
Each Fibre Channel port is configured separately.
The page displays the Port Name and Node Name
for each port. Choose the port to display a list of
attached devices for each bus. Configurable
options are
• Hard Address assignment
• Data rate
• Connection mode
• Hard Address values
Refer to
Fibre Channel configuration
commands
on page 48 for details.
iSCSI Configuration
Configurable options are
• iSCSI Alias
• iSCSI Port Number
• iSNSLoginControl
• iSNSServer
• SpeedWrite
Refer to
iSCSI commands
on page 51 for details
on each parameter.
Auto Target Management
ExpressNAV is the preferred interface for setting
up targets. On this page you can map devices
automatically to the default target or map each
device to its own target. By default, Access
Control and CHAP are disabled.
Refer to
Target management
on page 11, and
Mapping commands
on page 53 for details.