Filter
Top Products
39
Alternative interfaces: CLI
6.1.2 General use commands
These CLI commands are used in a variety of situations
Help
Displays a list of available commands. If command
name is specified, displays detailed command-
specific information.
Immediate command: Help [command name]
Password
Specifies a password for all sessions: TCP/IP, FTP
and ExpressNAV web-based interface. You will be
prompted for the current password, to enter the new
password, and to confirm the new password.
Passwords are case sensitive, 0-32 characters with
no spaces.An empty password can be configured by
entering the Password confirmation prompts with no
parameters. The command
RestoreConfiguration
default
sets the password to its default value.
Default: Password
Set syntax: set Password
Requires a SaveConfiguration command
ReadOnlyPassword
Specifies a read only password for all sessions:
TCP/IP, FTP and ExpressNAV web-based interface.
You will be prompted for the current password, to
enter the new password, and to confirm the new
password. Passwords are case sensitive, 0-32
characters with no spaces.An empty password can
be configured by entering the Password
confirmation prompts with no parameters. The
command
RestoreConfiguration default
sets the
password to its default value.
Default: Password
Set syntax: set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies a read only username for all TCP/IP, FTP
and ExpressNAV web server sessions. Username is
case insensitive, 1-32 characters with no spaces.
Default: user
Set syntax: set ReadOnlyUsername [username]
Requires a SaveConfiguration command
Get syntax: get ReadOnlyUsername
RestoreConfiguration
Restores configuration to either the default
configuration or the configuration last saved into
non-volatile memory. The saved option will undo
any changes made since the last save.
Immediate command: RestoreConfiguration
[Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration
command to be executed. This will be indicated by
the return
Ready. *.
When you invoke
SaveConfiguration
, the current
configuration is permanently saved in the iPBridge
and the new configuration becomes the active
configuration.
If a firmware restart is required to make the
requested change permanent, you will see a prompt
asking you to confirm the restart. You can override
this request by indicating the override value on the
command line.
You may make several changes through commands
and
SaveConfiguration
before implementing the
restart, but once you have restarted the iPBridge, all
the command changes created before the restart and
save will be implemented. If you select the restart
option, the iPBridge will execute its complete start
up cycle.
Restart
or
no Restart
parameter is optional
Immediate command: SaveConfiguration <Restart|
NoRestart>