Avaya P334T-ML Switch User Manual


 
Chapter 12 Avaya P330 Layer 3 Features
148 Avaya P334T-ML User’s Guide
Policy Configuration
Policy Configuration Overview
The P330 supports QoS (Quality of Service) by using multiple priority levels and
IEEE 802.1p priority tagging to ensure that data and voice receive the necessary
levels of service.
The Avaya P330 can enforce QoS policy on routed packets and change their 802.1p
priority, according to the following criteria:
The packet protocol
Matching the packet's source or destination IP address to the configured
priority policy.
Whether the packet source or destination TCP/UDP port number falls within a
pre-defined range.
In addition, the 802.1p priority of a packet can be modified according to the DSCP
value in the IP header based on the DSCP-802.1p mapping configured by the user.
The P330 supports Access Control policy. Access Control rules define how the P330
should handle routed packets. There are three possible ways to handle such packets:
Forward the packet (Permit operation)
Discard the packet (Deny operation)
Discard the packet and notify the management station (Deny and Notify)
The Avaya P330 can enforce Access Control policy on each routed packet, according
to the following criteria:
Matching the packet's source or destination IP address to the configured Access
Control policy.
Determine if the packet protocol and source or destination TCP/UDP port
number falls within a pre-defined range.
Using the ACK bit of the TCP header.
The P330 uses policy lists containing both Access Control rules and QoS rules. The
policy lists are ordered by rule indexing.
The Avaya P330 access control rules are set-up using the Command Line Interface
and Avaya EZ2Rule central policy management application under Avaya™ MSNM
(MultiService Network Manager).
Policy Configuration CLI Commands
In order to... Use the following command...
Set the default action for a given
Policy List.
ip access-default-action