Filter
Top Products
Chapter 10 Switch Configuration
64 Avaya P334T-ML User’s Guide
You can also download image files to the switch. The image files provide the
switch’s embedded software, embedded Web software, and Power over Ethernet
(PoE) software.
L Only parameters that differ from the factory default settings for the switch are
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch.
The P330 commands for uploading and downloading device configuration files
differ for the Layer 2 and Layer 3 configuration files.
L To upload or download files, you must log in to the device as a user with
Supervisor level privileges.
Layer 2 Configuration File
The Layer 2 configuration file contains the full Layer 2 configuration of the switch in
the format of the CLI commands necessary to configure the device to its current
configuration. The user can edit the file in a text editor, however, it is recommended
that configuration changes are performed using the MSNM P330 Device Manager
and/or the CLI. To upload or download Layer 2 configuration files, you must be in
a switch mode.
Use the CLI commands briefly described below for uploading and downloading
Layer 2 configuration files.
The rules of syntax and output examples are all set out
in detail in the Reference Guide.
In order to... Use the following command...
Download a startup configuration
file to the device using SCP (only
applicable when the device mode is
Layer 2)
copy scp startup-config
Note:To use the startup
configuration file, run the
copy running-config
starting-config command
after the configuration file is
downloaded to the device.
Download a module configuration
file to the device using SCP
copy scp module-config
Download a stack configuration file
to the device using SCP
copy scp stack-config