Filter
Top Products
Chapter 8 User Authentication
50 Avaya P334T-ML User’s Guide
The following RADIUS commands are accessible from Supervisor level.
For a complete description of the RADIUS CLI commands, including syntax and
output examples, refer to Avaya P330: Reference Guide.
Telnet Client Support
Introduction to Telnet
The P330ML supports invocation of a Telnet client from the CLI. The Telnet client
implementation enables you to control the destination port for connecting daemons
that listen on a non-default port.
Authentication when connecting to the switch via Telnet is identical to standard
console connection authentication (local or RADIUS).
In order to... Use the following command...
Enable or disable authentication for
the P330 switch. RADIUS
authentication is disabled by
default
set radius authentication
Set a primary or secondary
RADIUS server IP address
set radius authentication server
Configure a character string to be
used as a “shared secret” between
the switch and the RADIUS server
set radius authentication secret
Set the RFC 2138 approved UDP
port number.
set radius authentication udp-port
Set the number of times an access
request is sent when there is no
response
set radius authentication
retry-number
Set the time to wait before
re-sending an access request
set radius authentication retry-time
Remove a primary or secondary
RADIUS authentication server
clear radius authentication server
Display all RADIUS authentication
configurations. Shared secrets are
not displayed.
show radius authentication