Filter
Top Products
Chapter 8 User Authentication
Avaya P334T-ML User’s Guide 53
Allowed Protocols
Allowed Protocols Introduction
With the Allowed Protocols feature, the network manager can determine the IP
protocols enabled on the switch. This feature can be used to block access to the
switch using specific IP protocols. Each protocol can be independently enabled or
disabled on the switch.
L Enabling and disabling the Recovery Password protocol can only be done using
a direct console connection via the Console port.
Allowed Protocols CLI Commands
The following Allowed Protocols commands are available.
Show the IP addresses of the
managers that are allowed to access
the device
show allowed managers table
Show whether the status of allowed
managers is enabled or disabled
show allowed managers status
Show the IP addresses of the
managers that are currently
connected
show secure current
In order to... Use the following command...
Enable Telnet on the switch ip telnet enable
Disable Telnet on the switch no ip telnet
Enable HTTP on the switch ip http enable
Disable HTTP on the switch no ip http
Enable the switch agent to accept
ICMP redirect packets sent to it
ip icmp redirect
Enable the switch agent to ignore
ICMP redirect packets sent to it
no icmp redirect
Enable SNMP on the switch snmp-server
In order to... Use the following command...