Filter
Top Products
Operators Manual
ALS 330/430
Release 4/06 Page 43 Menu structure
Stop position ___________________________________________________ STOD
Function: Stop position of the label at the dispensing edge.
Available: Always
Range: 0.0 .... 200.0 mm
Product length ___________________________________________________PRDL
Function: The product length avoids multi labelling in case of difficult products. Normally it is set
to AUTO. This means that the product length is set to the label length.
After the product sensor has detected the edge of the product all signals that might be triggered
while the product is passing the product sensor are inhibited. This function can be helpful in
cases where the product is transparent or has several detection marks or edges. Such a case
is shown below.
The product sensor supplies several signals while the product passes the product sensor. If the
PRDL is not adjusted according to the dimension of the actual product the warning W_0 may
be given of false multiple product detection signals. The defined product length suppresses all
signals after the first product sensor signal has been received.
By pressing the keys FUNCTION the parameter PRDL is selected. The data input is selected
by pressing the key ENTER.
If an applicator is fitted to the labeller, the product length is not defined as a distance but as the
time that the product needs to pass the product sensor. The time is adjustable between 5 and
9999 ms.
Available: Always
Range: AUTO or 5 - 999 mm
Label position_____________________________________________________POS
Function: Position of label on the product.
Only available if no applicator is used.
Range: up to 999.9 mm in steps of 0.1 mm.