Filter
Top Products
Chapter 5: CCM Appliance Commands 55
Syntax
NFS ENABLE [IP=<nfs_server>] [MOUNT=<mount>] [FTYPE=LINEAR|DAILY]
[PROTOCOL=TCP|UDP]
-or-
NFS DISABLE
Examples
The following command enables the use of the NFS on the CCM appliance. The NFS server is
located at IP address 192.168.52.50, and files will be created under the subdirectory c/ccm_history
every midnight.
nfs enable ip=192.168.52.50 mount=c/ccm_history ftype=daily
The following command disables using the NFS feature on the CCM appliance. If NFS is later
enabled again without additional parameters, the previously configured values will be used.
nfs disable
NTP Command
The NTP command enables or disables use of the Network Time Protocol on the CCM appliance,
and specifies the location of the NTP server that will supply the time to the CCM appliance. For
more information, see Updating the Appliance Clock on page 14.
When you enable NTP, you are prompted to confirm or cancel the operation.
Table 5.3: NFS Command Parameters
Parameter Description
ENABLE Enables NFS on the appliance.
IP=<nfs_server>
IP address of the NFS server, in IP dot notation. The NFS server must support NFSv3
(RFC1813). This parameter is required if NFS is being enabled for the first time.
MOUNT=<mount>
Mount point (subdirectory location) on the NFS server. This parameter is required if
NFS is being enabled for the first time. The NFS server must be configured to allow
the CCM appliance to access this file system location.
FTYPE=LINEAR|DAILY
Linear indicates a file will be opened on the NFS server for writing at the end (appended).
Daily indicates a new file will be created on the NFS server every midnight.
For either file type, if the file being opened does not already exist, it will be created. If
the file already exists, it will be opened for writing at the end (appended).
Default = Linear
PROTOCOL=TCP|UDP
Specifies the network protocol to be used between the CCM appliance and the
NFS server.
Default = TCP
DISABLE Disables NFS on the appliance.