Filter
Top Products
68 CCM Installer/User Guide
Server Init command
The Server Init command reinitializes the CCM appliance configuration database, that is, restores it
to default values. You may choose to retain only the network address information.
When you enter this command, you are prompted to confirm or cancel the reinitialization.
You may also reinitialize the CCM appliance in hardware. See Reinitializing on page 11 for
more information.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER INIT CONFIG|ALL
Server PPP command
The Server PPP command enables or disables the PPP server on the console port. For more
information and requirements, see Using PPP on page 19 and Configuring and using dial-in
connections on page 19.
Once the PPP server has been configured with this command by specifying the required addresses
and masks, those values remain in the database. Later, if you disable the PPP server and wish to
reenable it with the same addresses, you don’t need to specify the address values again.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER PPP DISABLE|ENABLE
[LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]
Table 5.16: Server Init Command Parameter
Parameter Description
CONFIG Reinitializes the appliance but retains the IP address, subnet mask and gateway.
ALL Reinitializes the appliance, including the network address information.
Table 5.17: Server PPP Command Parameters
Parameter Description
DISABLE|ENABLE Disables or enables the PPP server.
LOCALIP=<local_ip>
IP address to be used to connect the CCM appliance over the PPP connection. Must
be on same subnet as REMOTEIP address.