Filter
Top Products
18
Installation Connecting the Daisy-Chain Cable
Connecting the Daisy-Chain Cable:
3. Begin with BANK 00. Using the Daisy-Chain Cable (F1D9402-XX),
connect one end to the “Daisy-Chain OUT” port on the primary
Rack-Mount Console KVM Switch.
4. Connect the other end of the Daisy-Chain Cable to the “Daisy-Chain IN”
port of the next KVM switch, normally BANK 01.
NOTE: It does not matter which unit is the primary unit, only that it is
connected “OUT-to-IN” or “IN-to-OUT”.
Adding additional units:
5. Continuing in the same manner, using the Daisy-Chain Cable
(F1D9402-XX), connect “Daisy-Chain OUT” to “Daisy-Chain IN” on
all subsequent units.
CAUTION: Never connect “Daisy-Chain IN” to “Daisy-Chain IN” or “Daisy-Chain
OUT” to “Daisy-Chain OUT”. This may produce unpredictable results.
Example of Daisy-Chain Configuration