Filter
Top Products
To stop a document being scanned
• Remove any unscanned sheets from the
document feeder tray.
• Press the
STOP button.
To stop a document being sent
During transmission:
• Press the
STOP button. Display shows
CANCEL=0. INTERRUPT=1.
Either
• Press
1 to postpone the current transmission
and return to standby. The document will
automatically be re-sent after 1 minute.
Or
• Press
0. Display shows the current session
number
DELETE SESS=xxx. PRESS ENTER.
• Press the
ENTER button to delete the
information or press the
STOP button to exit
and retain the information. Display shows
MEMORY TX. USER STOP and then returns to
standby.
• An error report is printed confirming the
transmission has been cancelled. This
setting can be switched off. (See page38.)
18
Using the BF900
To delete a batch dial
• Follow the stops shown under ‘To set up a
batch dial’ above and put in a START TIME
of 00:00.
• Press the
ENTER button to confirm.
Delayed sending
You can store a document in the memory and
set a time for it to be sent later.
• Load the document.
• Select the
RESOLUTION, TYPE ORG and PHOTO
settings if required.
• Press the
FUNCTION button. Display shows
FUNCTION MODE 0~9,#,*,<,>.
• Press
2 (or the buttons) to display
DELAY TX 0~9,#,*,>, ENTER.
• Press the
ENTER button. Display shows
TIME=00:00 PRESS ENTER.
• Set the time you want the fax to be sent
using the 24-hour clock e.g., 8.15am=
0815
and 6.30pm=1830. If you set an earlier time
than the present, the fax will be sent the
next day.
• Press the
ENTER button. Display shows
DELAY TX. SEL. LOC/START.
• Enter the number – you can use the keypad,
One-Touch button, Group Dial button or
Speed Dial code. Display shows
TEL=(NO)
PRESS START.
• Press the
START button. The document is
scanned and the display returns to standby.
FUNCTION ENTER
2
START
STOP
STOP
1
0
ENTER
ENTER