Filter
Top Products
BE-0901E-AC-PC• BE-1201B-AC-PC 6-31
Chapter 6 Embroidering
W1120Q
When “Semi-wide cap (ALL)” is selected.
Thread Trimming
! The following items can be set:
Enable inching Sets inching motion for thread trimming.
Hoop movement after
thread trimming
Sets the needle penetration length for trimming.
The length can be set in inches. To set the length in inch unit, select [Inch]
from the [Configuration] of Tool menu.
The available values are as follows:
For mm 0 - 100 mm (The standard value is 15 mm.)
For inch 0 - 3.9 inch (The standard value is 0.6 inch.)
Thread length (1-10)
for all machines
Sets the overall thread amount through the needle.
Value of 1 to 10 can be set. The smaller the value is, the shorter the length is.
Thread length after
thread trimming
Sets the overall thread amount through the needle.
Value of 1 to 10 can be set. The smaller the value is, the shorter the length is.
1. Select [Thread Trimming] from Settings menu.
2. Set inching, thread length, etc.
W1121Q
3. Click [OK].
The image is displayed upside down.
The speed is automatically adjusted
to 800 rpm or less.