Filter
Top Products
2-12 BE-0901E-AC-PC• BE-1201B-AC-PC
Chapter 2 Preparation of Embroidery Machine
3. Preparation for Embroidering
CAUTION
Turn off the power switch before starting preparation.
Failure to do so may start the machine unintentionally through an accidental activation of the START
switch, resulting in bodily injuries.
3-1 Upper Threading
!
!!
! BE-0901E-AC-PC
W1572 W1573
1. Pass an upper thread from the cotton stand through the holes of the thread guide right above each
cotton stand bar. When passing the thread, pass it through the first hole from the lower side, lead it
around the thread guide, and then pass it through the second hole also from the lower side.
2. Push up the thread guide tension disc with your finger, and pass it from the left to the lower hole.
Wind the thread clockwise twice around thread breakage pulley [2].
3. Pass the thread through the hole of upper thread guide(upper) [3]. Wind the thread clockwise once
around the rotary tension disc and place it on the spring.
4. Pass the thread through each hole of upper thread guide(middle) [4] and thread guide(upper) [5].
5. After passing the thread through the hole of thread guide(upper) [5], insert the thread into the right
side of the inner thread guide and pass it through the hole of the thread take-up.
6. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A [6] and lower thread guide [7].
7. Pass the thread through the hole of the needle bar thread guide [8] and pass it through the needle
eye. Do not pass it through the presser foot. Pass it to needle bar thread guide at the front of lower
thread guide [7].
[6]
Thread guide A
[8]
Needle bar thread
guide
[1]
Thread guide
tension disc
[2]
Thread breakage pulley
[3]
Upper thread
guide (upper)
Spring
Inner thread guide
[4]
Upper thread
guide (middle)
[7]
Lower thread guide
[5]
Thread guide (upper)
[7]
Lower thread guide