Filter
Top Products
BE-0901E-AC-PC• BE-1201B-AC-PC 11-3
Chapter 11 Error code list
Code Error Measures
E-21
Hoop overhang (+X)
E-22
Hoop overhang (+Y)
E-23
Hoop overhang (+X, +Y)
E-24
Hoop overhang (-X)
E-25
Hoop overhang (+X, -X)
E-26
Hoop overhang (-X, +Y)
E-27
Hoop overhang (+X, -X, +Y)
E-28
Hoop overhang (-Y)
E-29
Hoop overhang (+X, -Y)
E-2A
Hoop overhang (+Y, -Y)
E-2B
Hoop overhang (+X, +Y, -Y)
E-2C
Hoop overhang (-X, -Y)
E-2D
Hoop overhang (+X, -X, -Y)
E-2E
Hoop overhang (-X, +Y, -Y)
E-2F
Hoop overhang (+X, -X, +Y, -Y)
E-31
Needle overhang (+X)
E-32
Needle overhang (+Y)
E-33
Needle overhang (+X, +Y)
E-34
Needle overhang (-X)
E-36
Needle overhang (-X, +Y)
E-38
Needle overhang (-Y)
E-39
Needle overhang (+X, -Y)
E-3C
Needle overhang (-X, -Y)
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area on the panel or move the hoop to
the sewable position.
E-41 Invalid start-up error Turn the power off and on once.
E-42 XY movement error
Press the
.
E-43 Slave I/F EEPROM read error
Turn the power off and on once. If the same error occurs again,
the main PC is faulty.
E-A1 Spindle motor lock
Press the If it occurs frequently, the main shaft
mechanism is faulty.
E-A5 Spindle motor CPU error
E-A6
Main shaft motor CPU communication
command error
E-A7 Main shaft motor CPU send/receive error
This is not usually displayed.
E-A8 Main shaft stop position signal error
Adjust the pulley stop position (100 degrees) above the needle
and press the
If the error occurs frequently, the parts
related to the main shaft stop position sensor are faulty.
E-A9 Spindle CPU parameter error This is not usually displayed.
E-C1 Area over during embroidering Set the embroidering area again on the panel.
E-C2 Wiper out error
If the wiper is tangled with a thread, remove it. Press the
.
E-C3 Embroidering data buffer empty
E-C9 Embroidering start error
E-CA No sewing permisson
This is not usually displayed.