Filter
Top Products
BE-0901E-AC-PC• BE-1201B-AC-PC 13-3
Chapter 13 Connection and Installation of Optional Equipment
! Winding lower thread
W1638
1. Turn on the power switch.
2. Fit bobbin [1] to the bobbin winder shaft [2].
3. Pass a thread through thread guide [3].
4. Wind the thread around bobbin [1] several times in the direction of the arrow.
5. Press bobbin hold [4].
Note) • If the thread cannot be wound evenly, loosen screw [5] and move thread guide [3] from side to side
for adjustment.
• To wind more thread around the bobbin, loosen screw [5] and shift bobbin hold [4].
6. After winding is finished, remove the bobbin from the bobbin winder shaft and trim the thread using
tread trimmer [7].
Note) • If the thread passed though thread guide [3] comes off, loosen knob [8]. If the thread is wound
loosely, tighten knob [8].
• If circuit protector [9] is activated, the bobbin winder motor does not rotate. Wait for a while until the
motor cools and press the circuit protector. (If the motor is still hot, the pressed circuit protector will
come out.)
[3]
[5]
[8]
[7]
[2][1]
[9]
[4]
[6]