Filter
Top Products
Troubleshooting
73
12
My scanner cannot be
turned on or is turned
off immediately.
The battery has not been inserted. Insert the battery.
The battery has been inserted in the
wrong direction.
Insert the battery in the correct direction. For more
information, see Installing the battery on page 9.
• The battery is empty.
• The battery is low.
• The scanner’s Wi-Fi
®
switch is ON.
Do one of the following:
• Slide the scanner’s Wi-Fi
®
switch to OFF to use
the scanner.
• Connect the Micro USB Cable to your scanner
and your computer to use the scanner. If you
cannot turn on the scanner when you press the
Power button, wait for two minutes, and then
press the Power button again.
• Turn off the scanner and connect the Micro USB
Cable to your scanner and your computer until
the battery is charged fully. And then use the
scanner.
When I set the Wi-Fi
®
switch to ON, the
Wi-Fi
®
indicator does
not turn on.
The battery is low. Connect the Micro USB Cable to your scanner and
your computer to charge the battery.
The Li-ion battery is not installed. Install the battery, and then charge it.
I lost the Li-ion battery
or I cannot charge the
battery.
Causes may vary. Contact Brother Mall at
http://www.brothermall.com
.
My computer cannot
access the SD card via
the Micro USB Cable.
The Micro USB Cable is not connected
to your computer.
Connect the Micro USB Cable to your scanner and
your computer.
Your scanner is in TWAIN mode. Press the Start / OK button, and then display SD on
the LCD to change to Mass Storage mode (SD
mode).
The Wi-Fi
®
switch is set to ON. Slide the Wi-Fi
®
switch to OFF.
A document is being scanned. When the scanning is finished, wait for the SD
card’s folder to be displayed on your computer
screen.
When I type
http://10.10.100.1 to
access the home
screen in the web
browser, the scanned
images stored on the
scanner’s SD card are
not displayed on the
home screen.
Your scanner is in TWAIN mode. Press the Start / OK button, and then display SD on
the LCD to change to Mass Storage mode (SD
mode).
Your scanner is scanning a document. Display the web browser again when scanning is
complete.
Difficulty Cause Suggestions