Filter
Top Products
4
CHAPTER FOUR
Initial
Setup
31
Getting Started
Setting the Dialling Mode (Tone/Pulse)
Your machine is initially set to TONE. If you are using a PULSE dial
line, you can change the setting to PULSE by following the steps below.
1
Press Menu, 1, 1. The screen prompts you to select TONE or
PULSE.
DIALLING:TONE
DIALLING:PULSE
2
Use Z or X to select the dialling mode.
3
Press Set when the screen displays the dialling mode you want.
4
Press Stop to exit.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements
for correct operation. It is therefore strongly recommended that the
equipment is set to use the Tone signalling for access to public or private
emergency services. The Tone signalling also provides faster call set up.
Setting the Date and Time
Your machine displays the date and time, and prints it on every fax you
send.
In the event of a power failure, the machine maintains date and time
information for about 15 hours. All other settings remain unaffected.