Filter
Top Products
Troubleshooting and routine maintenance
139
C
c Wipe the outside of the machine with a
dry, lint-free soft cloth to remove dust.
d Remove any paper that is in the paper
tray.
e Wipe the inside and the outside of the
paper tray with a dry, lint-free soft cloth
to remove dust.
f Re-load the paper and put the paper tray
firmly back in the machine.
g Plug the machine’s power cord back into
the electrical socket first, and reconnect
all cables and telephone line cord. Turn
on the machine.
Cleaning the scanner C
a Turn off the machine. Unplug the
telephone line cord first, disconnect all
cables and then unplug the power cord
from the electrical socket.
b Lift the document cover (1).
Clean the white plastic surface (2) and
scanner glass (3) underneath it with a
soft lint-free cloth moistened with water.
c In the ADF unit, clean the white bar (1)
and the scanner glass strip (2)
underneath it with a soft lint-free cloth
moistened with water.
d Plug the machine’s power cord back into
the electrical socket first, and reconnect
all cables and telephone line cord. Turn
on the machine.
Note
In addition to cleaning the scanner glass
and glass strip with a soft lint-free cloth
moistened with water, run your finger tip
over the glass to see if you can feel
anything on it. If you feel dirt or debris,
clean the glass again concentrating on
that area. You may need to repeat the
cleaning process three or four times. To
test, make a copy after each cleaning.
1
3
2
1
2