Filter
Top Products
29
The print job is
not printed.
If a DHCP/BOOTP server or a
RARP server resides on the
network, the IP address is
automatically issued by the
server. In this case, the IP
address that was manually set
for the PS-9000 may have
been overwritten by the
server.
Create a local environment where the server does
not exist and issue the IP address to the PS-9000. At
the same time, make sure that “Obtain an IP address
automatically” in the TCP/IP setting is not marked.
If the PS-9000 and the
computer are not in the same
segment, a subnet mask and
gateway address must be set
for the PS-9000.
Use the Brother PS-9000 Utility to check whether
the subnet mask and gateway address are correct.
Check the printer port name of the PS-9000. The
port name is indicated by “(PTLAN xxxxxx: P-touch
TCP Port)” after the assigned port name.
Dial-up starts
when printing
is performed.
Depending on the operating
system being used, the
automatic dial-up setting may
have been specified.
When using PS-9000, cancel the setting for
automatic dial-up or, if the automatic dial-up setting
cannot be cancelled, click [Cancel] in the dialup
dialog box to begin printing.
An error
occurs during
printing.
If the unit stopped operating
because of a tape width error
or no more tape in the cassette
during another user’s print job,
printing is not possible until
the error is cancelled.
After the other user’s print job is finished, try printing
again. Otherwise, use the Web browser to restart
the PS-9000, and then try printing again.
LPR printing is
not available
with PS-9000.
With some of the P-touch
machines, LPR printing is not
available.
With the PT-9200DX, install the printing software
for the PS-9000 onto each client, and use it instead
of using LPR printing.
The tape width
cannot be
detected by
P-touch Editor 4
or Quick Editor.
If PT-9500PC is connected to
the PS-9000, the tape width
detection function of P-touch
Editor 4 and Quick Editor does
not operate. (There is no tape
width detection function with
PT-9200DX.)
Manually specify the tape width.
Can the PS-9000
be initialized
(reset to its fac-
tory default set-
tings)?
PS-9000 can be initialized (reset to its factory default
settings) by using the Brother PS-9000 Utility.
Select PS-9000 in the PS-9000 setting dialog box of
the Brother PS-9000 Utility, and then click
[Initialize]. Otherwise, the PS-9000 can be
initialized by pressing the push button. For further
information on how to initialize PS-9000 by pressing
the push button, refer to “Parts and Functions” in
chapter 1, “About PS-9000”.
Symptom Cause Remedy