58
LifeBook S Series – Section Four
TO REMOVE A MEMORY UPGRADE MODULE
1. Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook. (Figure 4-15)
Figure 4-15 Removing a Memory Upgrade Module
4. Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover.
6. Replace the screws.
CHECKING THE COMPUTER RECOGNITION
OF NEW MEMORY CAPACITY
Once you have changed the system memory capacity
by either adding or removing a memory upgrade
module, be sure to check that your notebook has
recognized the change.
You can check the memory capacity by looking at the
main menu of the BIOS setup:
1. Turn on the power to your notebook using the
power switch.
2. Allow the system to start booting and press the [F2]
key once the Fujitsu logo appears on the screen. This
will open the main menu of the BIOS setup with the
current settings displayed. (See BIOS Setup Utility on
page 33 for more information)
The System Memory and the Extended Memory capacity,
as detected by your notebook during the Power On Self
Test (POST), are displayed at the bottom of the main
menu screen. The chart below shows you the possible
displays that can be shown on the main menu screen.
POINT
After installing your memory module, you must com-
plete the Resetting the Save-to-Disk Parameters proce-
dure in order for the Save-to-Disk mode to operate
properly on your LifeBook.
(See Save-to-Disk Mode on
page 36 for more information)
POINT
If the total memory displayed is incorrect, check that
your memory upgrade module is properly installed. (If
the module is properly installed and the capacity is still
not correctly recognized, see Troubleshooting.
(See
Troubleshooting on page 67 for more information)
Installed Displayed
Slot 1
64MB
128MB
Total RAM
Installed
64MB
128MB
System
Memory
640K
640K
Extended
Memory
63MB
127MB