Filter
Top Products
GARP Operation Status Screen
Local Management Supplement 4-5
GVRP (Toggle)
Sets the port to operate as a GVRP-aware port. The setting is only valid if
the GVRP Protocol field near the bottom of the screen is set to Enable.
The GMRP field setting toggles between Y (yes) and N (no). The default
is “Y”.
To set the port, refer to Section 4.3.1.
Set All Ports (Selectable)
Sets all ports to the same setting by selecting one of the following:
• GMRP Enable All – Sets all ports as GMRP-aware ports. All ports are
set to Y under GMRP.
• GMRP Disable All – Sets all ports as not GMRP-aware ports. All
ports are set to N under GMRP.
• GVRP Enable All – Sets all ports as GVRP-aware ports. All ports are
set to Y under GVRP.
• GVRP Disable All – Sets all ports as not GVRP-aware ports. All ports
are set to N under GVRP.
• Enable All – Sets all ports to Y for both GMRP and GVRP.
• Disable All – Sets all ports to N for both GMRP and GVRP.
To set all ports, refer to Section 4.3.1.
GMRP Protocol (Toggle)
Enables or disables the GMRP Protocol on the switch.
When set to Enable, all port settings are valid for GMRP, enabling those
ports to send/receive frames to other GMRP-aware switches. Disable
makes the port settings invalid.
The default setting is “Disable”.
To enable or disable the protocol, refer to Section 4.3.2.