Filter
Top Products
Repeater Level Security Configuration
Local Management Supplement 2-3
Figure 2-2 Repeater Level Security Configuration Screen
The following section defines the fields on the Repeater Level Security
Configuration screen.
Interface (Read-Only)
Indicates the interface connector (ENET 1 through 4) selected in the
Interface field.
Security State (Selectable)
Used to set all ports on an interface connector to the same security state.
PortMismatch displays for an interface connector when all the ports on
the interface connector are not set to the same state. The selectable states
are as follows:
• NonSecure – Allows the ports on the connector to receive all frames.
The source address of received frames is not examined and the frames
are processed in a non-secure state.
• LockedOnAddr – The Security State of all ports on the specified
interface connector are set to LockedOnAddr. This setting is for
convenience, so that all ports on an interface connector can be set to
LockedOnAddr at one time. Until the address is set at the port level,
the port defaults to the locked on address of “00-00-00-00-00-00” as
indicated by “XX-XX-XX-XX-XX-XX” in the address field shown in
the Port Level Security Screen, see Figure 2-3.
Interface Security State Action On Intruder
1 [NonSecure]
2
[NonSecure]
3 [LockOnNext] [DisablePort] [SendTrap]
4 [LockedOnAddr] [DisablePort] [NoTrap]
SAVE EXIT RETURN
2971_112w