Filter
Top Products
Repeater Configuration Menu Screens
Local Management Supplement 1-37
[13 - 24] (Navigation Key)
When the Switch Configuration screen displays, the current screen
settings are displayed for the first 12 ports. This field is used to step to the
next screen for the same type of information for the next twelve ports, if
available. (The number of ports available is dependent on the
SmartSwitch model.) To navigate to the next screen, highlight the
[xx-xx]
field and press ENTER. The user can change the field settings while in
any of the selected screens.
1.13.2 Resetting the Reset Peak
To reset the peak level of the broadcast traffic, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak field for the selected
port.
2. Press the SPACE bar to select YES or NO.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays and the Time
Since Peak field is also reset.
1.14 REPEATER CONFIGURATION MENU SCREENS
The Repeater Configuration Menu screen and its subordinate security
screens are only displayed when using the repeater device 2E43-51,
2E43-51R, 2H23-50R, or 2H33-37R. The screens that will display
depend on the repeater device.
In the 2E43-51and 2E43-51R devices, the screens are the Repeater Level
Security Configuration and Port Level Security Configuration screens.
In the 2H23-50R and 2H33-37R devices, the screens are the Repeater
Configuration Menu screen and its two subordinate screens, Repeater
Level Security Configuration and Port Level Security Configuration
screens.
For a description of the screens associated with the 2E43-51 and
2E43-51R devices, refer to Chapter 2; for the 2H23-50R and 2H33-37R
devices, refer to Chapter 3. The screens enable the user to configure
operations and security at the connector and port level.