Filter
Top Products
Chapter 5: Local Management
5-70 2H23-50R/2H33-37R User’s Guide
5.19.2 Enabling /Disabling Ports
To enable or disable one or more ports, proceed as follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the number of the connector containing
the network(s) to be enable or disabled.
3. Use the arrow keys to highlight the MODE PORT STAT. field of the
network being enabled or disabled.
4. Use the SPACE bar to toggle to the appropriate setting (Enabled or
Disabled).
5. If setting more than one network, repeat steps 3 and 4 for each one and
then proceed to step 6.
6. Use the arrow keys to highlight the SAVE command.
7. Press ENTER. The message “SAVED OK” displays and all settings
are saved.
5.19.3 Setting All Ports
All the network ports on a connector can be set to the same operating
mode simultaneously using the SET ALL PORTS field, as follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Use the arrow keys to highlight the SET ALL PORTS field.
4. Use the SPACE bar to step to the appropriate Operating Mode
(Auto-Neg, 10Base-T, or 100Base-TX).
5. Use the arrow keys to highlight the SAVE command.
6. Press ENTER. The message “SAVED OK” displays and all networks
of the connector are set to the selected operating mode.