Filter
Top Products
Device Level Security Configuration
2H23-50R/2H33-37R User’s Guide 5-71
5.19.4 Enabling/Disabling Network Ports
All the network ports on a connector can be set to the same operating
mode simultaneously using the SET ALL PORTS field, as follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Use the arrow keys to highlight the SET ALL PORTS field.
4. Use the SPACE bar to step to the appropriate Operating Mode
(Auto-Neg, 10Base-T, or 100Base-TX).
5. Use the arrow keys to highlight the SAVE command.
6. Press ENTER. The message “SAVED OK” displays and all networks
of the connector are set to the selected operating mode.
5.20 DEVICE LEVEL SECURITY CONFIGURATION
The Device Level Security Configuration screen, Figure 5-27, is used to
set the state of security according to connector. All ports on a connector
can be set to receive all frames (NonSecure state), lock on the source
address of the next frame received (LockOnNext) or the source address of
the last frame received (LockedOnAddr). When either of the last two
options are set, the switch can be set to enable or disable the reception of
frames and send or not send traps.