Filter
Top Products
Interface Configuration View
Configuration Views 3Com PortSwitch Hubs
3-4 Management Module Guide
Interface Configuration View
This view provides information on the configuration and operating status of
the interface.
To access the Interface Configuration view do the following:
1. Within the Interface Device view, highlight the device icon.
2. From the Icon Subviews menu, select IF Configuration.
The Interface Configuration view provides the following information:
Operation Status
Displays the status of the module. Possible values are operational,
notoperational and unknown.
Admin. Status
Provides a menu button to set the Administrative status of the port. Once
disabled, a port must be explicitly enabled to restore operation. A port that is
already disabled when power is lost or when a reset is exerted will remain
disabled when normal operation resumes. Possible values are On, Off, and
Testing.
Last Change
Displays the system uptime at which the interface entered its current
operational state. A value of zero indicates that the status has not changed
since the agent was last restarted.
Network Name/Address
Displays the network name and the address at which it appears.
Physical Address
Displays the physical (MAC) address of the interface or port.
Bandwidth
Displays the interface bandwidth in bits per second. For interfaces that do not
vary in bandwidth or for which no accurate estimate can be made, this will be
the nominal bandwidth.
Packet Size
Displays the largest Maximum Transmission Unit (MTU) that can be
transmitted or recieved by the port, measured in octets.
Queue Length
Displays the length of the outbound packet queue in packets.