Filter
Top Products
Device Events and Alarms
Event and Alarm Messages 3Com PortSwitch Hubs
4-10 Management Module Guide
CsEvFormat/Event00ea0061
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that the
managed agent has recieved a reply to a
poll after a sequence of four or more un-
successfull polls. The addres is {S 1}
with protocol {T pprot 3}. (event [{e}])
No Probable cause message.
CsEvFormat/Event00ea0062
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that the
managed agent has not recieved a reply
to a poll after a sequence of four un-
successfull polls. The address is {S 1}
with protocol {T pprot 3}. (event [{e}])
No Probable cause message.
CsEvFormat/Event00ea0063
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that the
Resilient Backup Power Supply
connected to this repeater has
developed a fault. (event [{e}])
No Probable cause message.
CsEvFormat/Event00ea0064
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that the
Resilient Backup Power Supply
connected to this repeater has
recovered from a fault. (event [{e}])
No Probable cause message.
CsEvFormat/Event00ea0066
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that a port
{I 2} has seen an unrecognised MAC
address and is doing the following
action {I 1} (2=Notify, 3=Disconnect).
(event [{e}])
No Probable cause message.
CsEvFormat/Event00ea0067
{d “%w- %d %m-, %Y - %T”} A 3Com
Hub, {t} (name {m}) reports that a
repeater {I 2} has had its Bandwith
Used threshold {I 3} exceeded. The
Bandwith used is {I 1} (event [{e}])
No Probable cause message.
Table 4-1. 3Com PortSwitch Hubs Events and Alarms (Continued)
Message in the Event Log Alarm View Probable Cause
Message