Filter
Top Products
SuperStack Application
Application Views 3Com PortSwitch Hubs
5-18 Management Module Guide
This is a sequence of 16-bit numbers, each a pair of octets. Each encoded value
represents a repeater. The value of the field Repeater Num may be set to any
of the values in this list.
For example, is a port can be connected to repeaters 55, 92, and 333, the
encoding would be:
The final value would be 00.37.00.5c.01.4d.
Conn Type
Displays the connector type. Possible values are Unknown, RJ45, Telco, ST,
SMA, Female-DType-15, BNC, SC, Male-DType-15, and Cascade.
SuperStack Application
This application suppports the SuperStack Configuration view. The model
type name for this application is 3ComSSConfApp.
SuperStack Configuration View
This view provides the SuperStack Table. Double-click any field to access the
Stack Config Entry view, in which you can modify the Name and Attention
settings of a device.
Index
Displays a number used to identify individual devices in the stack. This value
will usually be contiguous but gaps may be present due, for example, to
unpowered devices.
Address
Displays the physical (MAC) address. Note that the index value can change if
devices are inserted into the stack, but that the physical address will not.
Last Reset
Displays the time, in hundredths of a second, since this device was last reset.
If a device is not operational, this will be zero.
Type
Displays a number that represents this type of device in the MIB.
The values of this integer are administered by allocating a MIB object
identifier for each type of unit from a common branch. The value of this object
is then the last level in that identifier. The values are defined in this MIB
Repeater 55 Repeater 92 Repeater 333
00.37 00.5c 01.4d