Filter
Top Products
Chapter 3: Installation
3-2 DLE22-MA, DLE32-MA, DLE23-MA and DLE33-MA User’s Guide
3.3 DLE2X-MA AND DLE3X-MA OPTIONS
If the DLE2X-MA is to be installed with an optional Fast Ethernet
Interface Module, refer to Appendix C for installation instructions. The
installation instructions for the HSIMs available for the DLE3X-MA are
located in the associated user’s guide.
3.4 INSTALLING THE DLE2X-MA AND DLE3X-MA
INTO THE DLM6C-AA CHASSIS
The DLE2X-MA and DLE3X-MA can be installed in any of the 5 slots
that are available. To install a module, proceed as follows:
1. Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling. (Save the blank plate in the event you need to remove the
module.)
2. Carefully remove the module from the shipping box. (Save the box
and packing materials in the event the module must be reshipped.)
3. Locate the antistatic wrist strap shipped with the DLM6C-AA chassis.
Attach the strap to your wrist and plug the cable from the antistatic
wrist strap into the ESD grounding receptacle at the upper right corner
of the DLM6C-AA.
Install any optional equipment before proceeding to
Section 3.4.
!
Failure to observe static safety precautions could cause
damage to the DLE2X-MA and DLE3X-MA. Follow static safety
handling rules and properly wear the antistatic wrist strap
provided with the DLM6C-AA chassis.
!
Do not cut the non-conductive bag to remove the module.
Damage could result from sharp objects contacting the board
or components.