Filter
Top Products
Using the Energy Saver Mode
This machine provides an Energy Saver mode. When no operations are performed
for about five minutes, the machine automatically enters the Energy Saver mode.
• You can specify the time until the machine enters the Energy Saver mode from 3 to
30 minutes.You can also turn off the Energy Saver mode. (See Chapter 4,
“Customizing Settings.”)
• The Energy Saver mode does not activate when the machine is in the following
states:
– When printing out copies or faxes* or other pages
– When sending or receiving faxes*
– While a copy job is saved in memory or when the reserve copy or other functions
are operating, or when the In Use/Memory indicator lights up*
– When paper jams occur
– When the platen unit is not returned to the original position
– When an error code appears and the Alarm indicator flashes
– When <PRESS SET KEY> is displayed
– When the toner is empty
– When the waste toner is full
* Only for the imageRUNNER 1670F model
Turning the Energy Saver Feature On or Off
1
Press [Energy Saver].
If the machine is in the Energy Saver mode when you press [Energy Saver], the
Energy Saver key light goes off and the machine enters the Standby mode.
The machine returns to the Full Power mode immediately. However, this time
may vary according to room temperature and circumstances.
If the machine is in the Full Power mode when you press [Energy Saver], the
Energy Saver key light goes on and the machine enters the Energy Saver
mode.
Always wait about five seconds after an operation completes before pressing
[Energy Saver].
Using the Energy Saver Mode 1-7
1
Before You Start Using This Machine
NOTE
NOTE
NOTE
**RG_Chap 01 3/4/04 7:40 PM Page 7