Filter
Top Products
4
Adjust the slide guides to fit the size of the paper stack.
If the slide guides are not adjusted correctly for the paper size, the quality of
your print images may be adversely affected.
• When making copies on letter size paper after having continuously copied on
paper smaller than letter size paper, the copies may be dirty. To prevent copies
from becoming dirty, wait about one minute before making copies.
• Insert the paper stack into the machine as far as it will go.
• If the paper is curled, uncurl it before placing it in the stack bypass. Failure to do
so may cause paper creases and/or paper jams.
• 16 to 32 lb bond (56 to 128 g/m
2
) paper is acceptable.
• Make sure that the paper stack does not exceed the paper limit guide.
• Some types of paper may not feed properly into the stack bypass. For high
quality copies, be sure to use the paper and transparencies recommended by
Canon.
• Load transparencies one by one.
• When making copies of a small size document or thick paper, the copy speed
may be slightly slower than usual.
• To specify the paper size every time you load the paper into the stack bypass,
follow these steps:
Press [4 ] or [e] to display/select the following menu items. Press [Set].
– Press [Additional Functions]
➞
<COMMON SETTINGS>
➞
<STACK
BYPASS SIZE>
➞
<OFF>
➞
<SET ON LOADING>
– Load the paper into the stack bypass
➞
select the paper size using [4 ] or
[e]
➞
press [Set].
For details, see “Selecting the Paper Feeding Location,” on p. 3-6.
5-10 Loading Paper
5
Routine Maintenance
NOTE
IMPORTANT
**RG_Chap 05 3/4/04 7:45 PM Page 10