Filter
Top Products
Field Test Unit Software
3.4.1 Running LOAD
1.
Connect Data Logger to FTU. (connect datacassette)
2.
Type:- RUN “LOAD” then press Return (or RUN “PLOT”)
3.
Answer the relevant questions described below
3.5
PRINTING
&
PLOTTING RECORDINGS
The program “PLOT” is used to print or plot the recorded information from
the Data Logger. This information may be from stored files in RAM or on
cassette or alternatively, “PLOT” will print/plot directly from a Data Logger
connected to the FTU.
3.5.1 Running PLOT
1.
Connect datacassette or Data Logger to FTU
2. Connect & RESET printer Or plotter to FTU
3.
Type:- RUN then press Return (or RUN “PLOT”)
4.
Answer the relevant questions described below
3.6 LOAD/PLOT - OPERATOR RESPONSES
Question
input from Keyboard
input from File; or
Create Command
file?
Answers
K = Keyboard entry of commands
F = Commands are to be read from a
previously created command file
C = Store entered commands in a
command
file
for future use
Enter the way you wish commands to be entered to the program
Note:- if
“C”
is selected, the program creates a command fife only. It
does
not perform any LOAD/COPY/PLOT function.
.
. .
Cassette or Ram file
C = Cassette storage
COMMAND file?
R = Ram storage
Enter the storage device of the command file
Section 3. (UN)LOAD, PLOT& COPY 11