Filter
Top Products
Field Test
Unit
Software
Enter scale size
(cm per hour)?
Field 2
bytes,from,to,units,
(location,start,end)
Field 2
bytes,from,to,units,
(location,start,end)
Field 3
bytes,from,to,units,
(location,start,end)
Field 4
bytes,from,to,units,
(location,start,end)
Check Data Start
Date & Time
15:54:40
21AUG’86
(Y/N)?
Check START
Date
&
Time
15:54:40
21AUG’86
(Y/N)?
Check END
Date
&
Time
15:54:40
22AUG’86
(Y/N)?
1 1cm of graph = lhour
RED,0,60,Deg C
Use red thermistor correction., range temp
from 0 to 60, label Deg C
RED,0,60,Deg
C
Use red thermistor correction, range temp
from 0 to 60, label Deg C
1,-10,60,Deg C,
Use red thermistor correction, range temp
from
0
to 60, label Deg C
1,-10,60,Deg C
Use red thermistor correction, range temp
from 0 to
60,
label Deg C
Y Yes this is when the first log occurred
Y Yes, start printing data from this point on
Y Yes, finish printing data at this point
3.7.3 LOAD
-
Example
The following two examples show the procedure to follow if a log program
is written on a host computer and then transferred into a logger via the
FTU.
LOAD
-
Example
1
Assume a log program was written by the UNIDATA IBM software pack-
age and is now to be loaded into RAM of the
FTU.
Note that the size of the log program determines the number of bytes to be
transferred to/from the
FTU.
The number of bytes to transfer is given by the
location of the last byte of the log program
-
384. The last byte of the log
program is specified by PDLASM at assembly.
18
Section
3.
(UN)LOAD, PLOT& COPY