Filter
Top Products
Field Test Unit Software
7.7.4 “r” - RESET *
This command resets the logger data storage to an original state. All data is
lost and the logger starts logging immediately.
7.7.5 “j” & “a” - JUMP TO LOG & ADDRESS toggle *
These two commands are used together to view data in the logger memory.
By pressing
“j”
the user can access specific logs. Selection of a log number
will cause the FTU to display the logged data. Use of the cursor key pad
wilI
enable the user to move through the logs.
By pressing “a” the user can interchange the bottom line from an address dis-
play to that of the loggers time reading at each specific log. If the screen is
cleared and set up prior to entering
“j”
then the
FTU
will display the logged
data in actual units rather than raw bytes.
7.7.6 “D” - DATA
This command will cause the FTU to prompt “Data Buffer (0-7)”. After
receiving the desired buffer number the FTU will then display information
on that buffer pointer from the logger.
7.7.7 “J” - JUMP to ADDRESS
Jump to address pointed to by the start, end or current pointer, (this infor-
mation can be displayed by the above command). The user will be required
to enter in the desired buffer number (0-7). The user can select the current,
end or start buffer by pressing “S”-start,
“E”-end
or “C”-current.
7.8 X-07
DIRECT COMMANDS FROM FTU-PROM
7.8.1 “t” - TIME
To reset the X-07’s internal clock/calendar type “t”. The new date if required
is entered by writing over the old date and then pressing “RETURN”.
Section 7. FTUC COMMANDS
37